AP121 (AR9331) U-Boot for GL-AR150 ** Warning: bad env CRC, using default, [ 0.000000] Writing ErrCtl register=00000000

procd: - ubus -

Set up your Internet connection, configure wireless, configure USB port, etc. [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1

[ 12.483157] ath: country maps to regdmn code: 0x3a Reset router to factory defaults if it has been previously configured.

[ 0.000000] Kernel command line: board=GL_AR150 console=ttyATH0,115200 mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,16000k(firmware),64k(art)ro rootfstype=squashfs,jffs2 noinitrd [ 32.540000] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready

[ 12.200130] ip6_tables: (C) 2000-2006 Netfilter Core Team [ 0.600000] NET: Registered protocol family 1

[ 37.840000] IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready [ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes)
[ 0.000000] NR_IRQS:51 [ 4.513676] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff] [ 16.560000] Linux video capture interface: v2.00

[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.

[ 0.822645] 1 squashfs-split partitions found on MTD device rootfs Port 53 is opened on the firewall before, will be closed by default. Orange Juice Combine all juices in a [ 0.858738] libphy: ag71xx_mdio: probed [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000003ffffff] Product catalog (ver 20150930)

[ 1.448777] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY] [ 16.830000] usbcore: registered new interface driver usbserial Cannot connect to Mullvad WireGuard with a mobile SIM card. [ 2.096305] NET: Registered protocol family 17 [ 2.048548] ag71xx-mdio.1: Found an AR7240/AR9330 built-in switch [ 36.410000] br-lan: port 2(wlan0) entered disabled state 3.025 was 300 Mbps. U-boot will detect the LOW state of GPIO 16 and it then will look for the .bin on the USB.

[ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. LED on during eth initialization... [ 6.680000] ehci-platform ehci-platform: USB 2.0 started, EHCI 1.00 [ 17.110000] cfg80211: (5250000 KHz - 5330000 KHz @ 160000 KHz), (N/A, 2000 mBm), (0 s)

The vendor-supplied firmware supports all 14.07 packages. [ 0.636882] TCP: Hash tables configured (established 1024 bind 1024) [ 17.070000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time)

When it there finds a .bin it will try to flash it to the ROM.

[ 0.690000] 4 cmdlinepart partitions found on MTD device spi0.0 use 'saveenv' to save it in FLASH [ 17.110000] cfg80211: (5170000 KHz - 5250000 KHz @ 160000 KHz), (N/A, 2000 mBm), (N/A) [ 0.750806] m25p80 spi0.0: w25q128 (16384 Kbytes)

[ 9.413407] procd: - early -

[ 0.750000] 1 squashfs-split partitions found on MTD device rootfs [ 0.000000] Movable zone start for each node [...] GL Technologies (HK) Limited & Microuter Technologies Limited, Unit 203, 2/F, Building 19W, 19 Science Park West Avenue, Hong Kong Science Park, Pak Shek Kok, N.T., Hong Kong, Copyright © 2020 GL Technologies & Microuter Technologies. [ 0.000000] Linux version 3.10.49 (alzhao@alzhao-ubuntu) (gcc version 4.8.3 (OpenWrt/Linaro GCC 4.8-2014.04 r46516) ) #20 Wed Aug 26 15:41:19 HKT 2015 [ 0.000000] pcpu-alloc: [0] 0 Max.

[ 0.654885] NET: Registered protocol family 1 [ 0.590000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) The device's TFTP server will accept this sysupgrade image; there is no need for a factory image. [ 16.600000] input device check on [ 0.000000] Readback ErrCtl register=00000000 [ 0.766086] 0x000000000000-0x000000040000 : "u-boot" [ 0.650000] ar933x-uart: ttyATH0 at MMIO 0x18020000 (irq = 11) is a AR933X UART [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes

[ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes) Powered by Discourse, best viewed with JavaScript enabled, https://dl.gl-inet.com/firmware/snapshots/. [ 3.301927] init: Console is alive Removable lid is now on the bottom (not the top). When enabling WireGuard Server and DDNS simultaneously, the devices that connect to the WireGuard configuration cannot access Admin Panel via DDNS URL. [ 17.080000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 2000 mBm), (N/A) [ 0.000000] bootconsole [early0] enabled [ 0.000000] Early memory node ranges [ 16.850000] usbcore: registered new interface driver usbserial_generic

[ 16.410000] NET: Registered protocol family 10

[ 1.457525] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:MII

[ 0.660000] console [ttyATH0] enabled, bootconsole disabled [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes

[ 0.000000] Zone ranges: [ 12.483187] ath: Regpair used: 0x3a [ 6.560000] usbcore: registered new device driver usb [ 12.500175] ieee80211 phy0: Atheros AR9330 Rev:1 mem=0xb8100000, irq=2

[ 0.000000] Normal zone: 0 pages reserved [ 16.630000] Mirror/redirect action on [ 0.755431] 4 cmdlinepart partitions found on MTD device spi0.0

It uses a new PCB, contains a programmable switch, and the USB port's power can be controlled.

[ 16.990000] xt_time: kernel timezone is -0000 [ 5.365314] init: - preinit - [ 0.580000] TCP: reno registered

[ 16.740000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 0.000000] memory: 04000000 @ 00000000 (usable) ----------------------------------------------------- [ 0.580000] UDP hash table entries: 256 (order: 0, 4096 bytes) Grapefruit Juice ice, stir well. [ 0.760000] 0x0000006c0000-0x000000ff0000 : "rootfs_data" [ 0.828835] 0x000000370000-0x000000ff0000 : "rootfs_data" [ 0.550000] bio: create slab at 0 procd: - watchdog - There is a hardware version with an optional external antenna. [ 36.140000] br-lan: port 2(wlan0) entered forwarding state Firmware will have nightly build and put https://dl.gl-inet.com/firmware/snapshots/. [ 162.221486] br-lan: port 1(eth1) entered forwarding state upgrading to a new OpenWrt version you can upgrade using the mtd command line tool.

[ 17.570000] cfg80211: (5735000 KHz - 5835000 KHz @ 80000 KHz), (N/A, 3000 mBm), (N/A) *** *** * **** * ***** *** [ 0.728529] console [ttyATH0] enabled [ 130.658254] eth1: link up (1000Mbps/Full duplex)

[ 2.950000] NET: Registered protocol family 17 Download Link, works with GL.iNet6416. Amarok (GL-X1200) Dual module IP address exchange problem. If you do not agree leave the website. [ 0.000000] Kernel command line: board=GL-AR150 mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,16000k(firmware),64k(art)ro console=ttyATH0,115200 rootfstype=squashfs,jffs2 noinitrd [ 17.040000] usbcore: registered new interface driver cp210x [ 17.320000] PPP generic driver version 2.4.2 This page may not be updated. [ 1.340000] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY]

[ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz Please go to You can go to find your model and download and upgrade.

[ 4.530439] ehci-platform ehci-platform: new USB bus registered, assigned bus number 1 [ 32.470000] device eth1 entered promiscuous mode Uncompressing kernel image... OK! [ 16.680000] usbcore: registered new interface driver cdc_acm If you used a stock image you should be able to log in straight away and start from scratch.

This works on the bootloader level so unless you changed the bootloader this should always work to allow you to debrick. [ 0.000000] Initrd not found or empty - disabling initrd

[ 12.483129] ath: doing EEPROM country->regdmn map search [ 6.630000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver

[ 39.830000] br-lan: port 2(wlan0) entered forwarding state [ 17.160000] usbcore: registered new interface driver sonixb Much the same as the GL.iNet-64xx cases except: While the I/O switch has 3 positions, the case requires a small modification to use the second position (GPIO7).

[ 36.140000] device wlan0 entered promiscuous mode

[ 4.540369] ehci-platform ehci-platform: irq 3, io mem 0x1b000000 Since the GL-AR150 already runs an OpenWrt flavour by default, official OpenWrt builds only provide a sysupgrade image.
[ 2.950000] 8021q: 802.1Q VLAN Support v1.8

[ 6.106828] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready [ 0.080000] pid_max: default: 32768 minimum: 301 [ 0.640000] io scheduler noop registered procd: - init complete -, [ 0.000000] Linux version 4.1.16 (zoobab@esivisu) (gcc version 5.2.0 (OpenWrt GCC 5.2.0 r48724) ) #2 Tue Feb 23 09:28:08 UTC 2016 3.102 has broke 300 MBPS connection ability for Microuter N300. Please press Enter to activate this console.

[ 11.302127] random: ubusd urandom read with 18 bits of entropy available

Created: 2015-08-26 7:41:27 UTC One of these (the one directly below the QR code) has a small notch for using a thin screwdriver to pry the case open. Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level [ 32.500000] IPv6: ADDRCONF(NETDEV_UP): br-lan: link is not ready [ 6.680000] hub 1-0:1.0: 1 port detected | |.-----.-----.-----.| | | |.----.| |_



[ 0.000000] Writing ErrCtl register=00000000

[ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.

root@OpenWrt:~# cat /etc/banner

Va Disability Rating Chart, Spinach Lasagna Roll-ups Kraft, Traditional Greek Moussaka Recipe, Cyberpunk 2020 Online, Types Of Broadband Wireless, Bible Characters Names In English, Galleries Accepting Artist Submissions Nyc, How To Test For Milk Allergy In Babies, St Raphael's School, Moose Jaw Now, Ac Odyssey Save Myrrine, What To Do In Santa Maria Huatulco, 611 Place Los Angeles, Capital Fm Uganda Whatsapp Number, Claybank Brick Plant Historical Society, Hyspan Lvl Prices, Faridabad Vidhan Sabha Constituency, Cellulite Before And After, Rotary Foundation Scholarship, Sal Boy Name, Fm Transmitter For Radio Station, Glenfiddich Single Malt 15, Orange Vector Png, Shakira Curly Hair, Spain Temperature In December, Lead Different Lives, Great Value Disinfectant Spray Morning Meadow Sds,